Saturday, January 5, 2008

Free Lens Hoods... Part II

Don't forget to Recycle...

Another great source for lens hoods is found in every day items around the house, namely plastic bottles.


About all it takes is some time and care and careful, slow going to cut the material appropriately and such that it fits properly. In this instance, the 40.5mm diameter of a typical Russky normal lens did not translate out perfectly to the diameter of the plastic bottle, and thus it was necessary to make the cut such that its slightly concave (as seen in the accompanying photo).


When fitted onto the lens, the plastic flexes slightly and exerts a bit more holding pressure than would naturally occur in a straightforward ‘press on’ fitting.


The now finished hood is painted a flat or matte black, and the job is complete. I consider this the “perfect” lens hood for one main reason: it didn’t cost anything but the few minutes work it took to make it.


To really finish it off you could use your PDF printout of a tulip petal-shaped hood to trim the front of the plastic bottle hood.


If you share this link please let everyone know you found it here at: freephotostuff.blogspot.com

Thanks.

0 comments:

Label Cloud